| MODEL | ACS-U40D13.8+13.8 |
| OUTPUT | Ouput Number | V1 (mains AC power) | V2 (battery power) |
| DC Output | 13.8Vdc | 13.8V |
| Rated Current | 2A | 0.2A-0.4A(constant current limit) |
| Current Range Note 1 | 0.05A – 2.0 | / |
| Ripple and Noise Note 2 | 0~60℃ | <100mV | / |
| -20~0℃ | <200mV | / |
| Voltage Accuracy | ±3.0% | / |
| Line Regulation | ±1.0% | / |
| Load Regulation | ±2.0% | / |
| Voltage Adjustable Range | 13.0-13.8Vdc |
| Set-up Time | ＜1.0S (230Vac input, Full load),<2.0S(115Vac input,Full load) |
| Hold up Time | ＞20mS(230Vac input, Full load),>10mS(115Vac input,Full load) |
| Temperature Coefficient | ±0.03%/℃ ±1.0%/℃ |
| Overshoot &Undershoot | <5.0% |
| Battery current during deep discharge | <1mA |
| INPUT | Voltage Range | 90Vac-264Vac (Rated:100Vac-240Vac) |
| Frequency Range | 47Hz-63Hz |
| Efficiency ( Typical) | 75%@230Vac, 72%@115Vac |
| AC Current (max.) | 1.2A |
| Inrush Current (Typical) | ＜50A@230Vac ;<30A@115Vac Cold start |
| Leakage Current | Input—Output: ≤0.25mA Input—PG: ≤3.5mA |
| PROTECTION | Deep discharge cut off | 9Vdc-10Vdc |
| Over Current | V1:2.5A-4.0A, hiccup mode,auto recovery |
| Over Voltage | V1: 110%-150%, constant voltage |
| Shorted Circuit | Long-time; auto recovery |
| Battery reverse polarity | Self auto-recovery fuse . |
| SIGNAL | AC OK / Fail signal | AC OK: Sig=0(0-1Vdc) Current<=50mA(this depends on customers control unit) AC Fail: Sig=1(voltage depends on customers control unit) |
| Status Indication | Green LED(LED1) | AC ON,the device is being supplied from the SMPS. |
| RED LED(LED2) | AC OFF,the device is being supplied from the battery backup device |
| ENVIRONMENT | Operating.Temp.& Hum. | -20℃~60℃; 20%~90%RH No condensing (refer to the derating curve) |
| Storage Temp. & Hum. | -40℃~80℃; 10%~95%RH No condensing |
| SAFETY &EMC (Note 3) | Safety Standards | UL60950-1; EN60950-1:2006;LVD 73/23/EEC |
| EMC | Compliance to EN55022(CISPR22)Class B EN55024; FCC 15.107, FCC15.109,EMC 2004/108/EC |
| Isolation Resistance | ≥100M ohms |
| OTHERS | MTBF (MIL-HDBK-217F) | More than 200,000Hrs (25℃, Full load) |
| Dimension (L*W*H) | 173.4×60×57.1mm |
| Cooling method | Cooling by free air convection |
| NOTE | - All parameters NOT specially mentioned are measured at rated input, rated load and 25℃ of ambient temperature.
- Measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1 uF & 47uF parallel capacitor.
- The SPS is considered a component which will be installed into final equipment. We cannot guarantee that the final equipment will meet EMC directives, Final product manufactures must be re-confirm that their product meets EMC directives.
|
| | Withstand Voltage | Primary-Secondary:3.0KVac;≤10mA.Primary-PG:1.5KVac;≤10mA.Secondary-PG:500VDC;≤10mA. |
